No Wet Wonder Foam Solution 

1. Vacuum carpet or upholstery before cleaning and after it's dried!
2. Shake bottle well before using. Mix approx. one cup using measure cup, of NoWet in a bucket with .5L warm water. Agitate mixture to produce foam.
3. Place applicator in solution and squeeze foam rollers to remove surplus water. Move applicator backward and forward gently on surface, always finishing with a forward stroke. After cleaning 2-3 square yards, rinse applicator with clean water. Load with foam from the bucket and continue.
4. Carpets should be dry to the touch in 20 minutes. Allow to fully dry for 3-4 hours and then vacuum. For high traffic areas a second application will produce best results. Pretreat heavily stained areas by applying NoWet at full strength. Wait for 20 minutes, and follow steps 1-4.

No Wet Wonder Foam Foamer Pump Bottle
Use the foamer pump bottle, for smaller areas.

1. Shake a 500ml bottle of NoWet Wonder Foam solution well.
2. Fill the Foamer Pump Bottle's cap with NoWet Wonder Foam solution and place in Foamer Pump Bottle.
3. Using the Foamer Pump Bottle's cap, add 2 capful of warm water.
4. Firmly close the Foamer Pump Bottle and shake well.
5. Pump a generous amount of foam on to the stain.
6. Rub with fingers, brush, or applicator until stain disappears.
7. Let air dry.
8. Any unused foam may be contained in the Foamer bottle until next use.*Remember to shake the Foamer bottle well before each application.
   

If no foam comes out, try one or all of the following:

• Make sure the cap is on securely and shake Foamer bottle well.   
• Remove cap/lid of the Foamer bottle and add more NWWFClose cap/lid and shake

Double Sided Mitt

1. Use the mitt for cleaning upholstery; two sided - white surface for heavyweight materials - blue surface for delicate materials.